Teklif İsteyin | Bize Ulaşın |

How is the Robustness Control Performed in the Resistors? Different techniques emerge when performing robustness control. The easiest and most precise technique is to check the electrical connection. If there is no electricity to the product, it is understood that the product is defective or not intact. Robust resistors, after receiving the required energy, release heat and provide electricity to the product. But unsound resistors cannot deliver electricity to the product. A break in connections occurs.

When checking the stability of the resistors, it is necessary to do it by people who know. Checking by people who do not know about the functioning of the resistors or about the resistance will not give results. One of the important considerations when checking the robustness is that there is no repair operation in case of a malfunction, the process that needs to be done is a resistance change.

The robustness control varies depending on the mastery. This method is usually preferred because it is an easy method to check the electrical connection and find the fault.

How is the Robustness Control Performed in the Resistors?
How is the Robustness Control Performed in the Resistors?

How is the Measurement Performed in the Resistors?

Measurement is an important factor in terms of resistance utilization. Thanks to this measurement, it is possible to determine whether the resistance is intact. There is a standard formula based on this measurement. the value obtained by the formula 220*220/ power of the resistor informs whether the resistor is intact. When making this measurement, the multimeter must be moved to the resistance position if you want to get a clear result, you need to remove one end of the resistor.

If the numbers that appear after the formula applied with this measurement are close to each other, the resistance is intact. People who want to check its robustness should obtain two values and compare them by measuring the resistance and applying the formula. This method often gives a definite result. If you want to know the technical characteristics and measurements of the resistor, you can find out from our other blog by clicking here.

How is Leakage in the Resistance Detected?

People who want to find out if there is a leak in the resistance should first check the chassis omage. In non-leakage resistors, there is a high Deceleration between the chassis and the resistance ends. If there is a lower omaj, it is understood that it is illegal. Leakage in the resistors should be carefully controlled, as it will cause problems when the resistance becomes active.

When performing the robustness test, it should also be noted whether the resistance is leaking or not. When there is a leak in the resistance, the mode of operation is directly affected. Therefore, it should be intervened in case of leakage.

Hemen Arayın
WhatsApp